Processing Videos
Workshop footage of real coating jobs: HVOF, plasma and arc spraying, roll grinding, fixturing and finishing.
2:41
Plasma Spray Turntable System Delivered to an Italian Customer
A multi-position turntable plasma spraying cell running at our Italian customer's facility - fixtures rotate through the spray zone so every part receives a uniform coating.
Watch video →
3:45
Factory Overview - Thermal Spray Equipment Manufacturing
A walkthrough of our production facility: the machining, assembly and test areas where SX-series thermal spray systems, spray guns and peripheral equipment are built and commissioned.
Watch video →
1:07
SX-60 Plasma Spraying Non-Stick Coating on Cookware
The compact SX-60 plasma spray system applying a ceramic non-stick coating to a pan interior - an entry-level cell for cookware factories and coating service shops.
Watch video →
0:27
SX-LP60 Low-Pressure Cold Spray System in Operation
The SX-LP60 low-pressure cold spray system building up dense metal coatings with compressed air instead of a combustion flame - ideal for repair and conductive coatings on sensitive parts.
Watch video →
1:00
Robotic Spraying a Large Framed Mesh Workpiece
A six-axis robot guides the spray torch across a large framed mesh panel, keeping a constant standoff for an even ceramic coating over the entire surface.
Watch video →
1:17
24-Station Rotary Disc Spraying System
A 24-station rotary indexing disc coating workpieces in continuous production - load, spray and unload in one cycle for high-throughput, consistent quality.
Watch video →
1:37
SX-5000 HVOF System Commissioning for a Canadian Customer
On-site acceptance test of the SX-5000 gas HVOF system at a Canadian customer's plant - start-up, spray parameter tuning and coating verification before handover.
Watch video →
21:06
Thermal Spray Technology Introduction
A general introduction to thermal spray technology - heat sources, spray processes, coating materials and typical industrial applications.
Watch video →
1:07
Single-Station Cookware Spraying
Spraying non-stick primer and top coats on cookware at a single enclosed station - a compact solution for small batches, samples and special sizes.
Watch video →
2:08
SX-600 Arc Spray Equipment Demonstration
The SX-600 twin-wire arc spray system in operation - high-deposition coatings of zinc, aluminum and anti-corrosion alloys.
Watch video →
0:09
Internal Bore Spraying with the SG-100 Gun
Coating the inside diameter of a bore with our SG-100 internal spray gun - a hard-to-reach area that most spray shops cannot coat.
Watch video →
2:06
Guide Roll Coating on the Spray Line
Surface preparation and spray coating of steel guide rolls used in paper, film and packaging lines - filmed on our production floor.
Watch video →
1:12
Battery Electrode Calender Roll Coating
Workshop footage of a calender roll coating job for lithium-battery electrode production: part set-up, tungsten carbide spraying and surface finishing.
Watch video →
0:26
HVOF Spraying of NiCr-CrC and NiCr Alloy Coatings
Supersonic HVOF spraying of NiCr-CrC and NiCr alloy powders onto steel components - dense, hard coatings for combined wear and corrosion protection.
Watch video →
0:10
Arc Spraying a Paper Machine Dryer Cylinder
Twin-wire arc spraying rebuilds the surface of a paper machine dryer cylinder - restoring diameter and improving release.
Watch video →